Coupling characteristics of laterally coupled gratings with slots

Laterally-coupled ridge-waveguide distributed feedback lasers fabricated without epitaxial regrowth steps have the advantages of process simplification and low cost. We present a laterally coupled grating with slots. The slots etched between the ridge and grating area are designed to suppress the lateral diffusion of carriers and to reduce the influence of the aspect-ratio-dependent-etching effect on the grating morphology in the etching process. Moreover, the grating height in this structure can be decreased to lower the aspect ratio significantly, which is advantageous over the conventional laterally coupled ridge waveguide gratings. The effects of five main structural parameters on the coupling characteristics of gratings are studied by MODE Solutions. It is found that varying the lateral width of the grating can be used as an effective way to tune the coupling strength; narrow slots (100 nm and 300 nm) and wide ridge (2 μm-4 μm) promote the stability of grating coupling coefficient and device performance. It is important to note that the grating bottom should be fabricated precisely. The comparative study of carrier distribution and mode field distribution shows that the introduction of narrow slots can strengthen the competitive advantage and stability of the fundamental mode.     

Neutron emission from fracturing of granite blocks: An experimental revisitation

A series of experimental tests, such as those of Carpinteri et al. (2013), have been performed. The aim was to check the emission of neutrons in the fracture of Luserna granite blocks under mechanical loading, as reported by the above mentioned authors. No neutrons have been detected and some doubts have emerged on the soundness of the previous measurements.     

多层网络级联失效的预防和恢复策略概述

现实生活中,与国计民生密切相关的基础设施网络大多不是独立存在的,而是彼此之间相互联系或依赖的,于是用于研究这些系统的多层网络模型随之产生.多层网络中的节点在失效或者遭受攻击后会因"层内"和"层间"的相互作用而产生级联效应,从而使得失效能够在网络层内和层间反复传播并使得失效规模逐步放大.因此,多层网络比单个网络更加脆弱.多层网络级联失效产生的影响和损失往往是非常巨大的,所以对多层网络级联失效的预防和恢复的研究具有重大意义.就多层网络级联失效的预防而言,主要包含故障检测,保护重要节点,改变网络耦合机制和节点备份等策略.就多层网络发生级联失效后的恢复策略而言,主要包含共同边界节点恢复、空闲连边恢复、加边恢复、重要节点优先恢复、更改拓扑结构、局域攻击修复、自适应边修复等策略.     

振型归一化对梁结构柔度曲率损伤指标的影响

结构柔度矩阵需由质量矩阵归一化振型获得,而质量矩阵归一化振型难以直接测得,限制了柔度曲率类损伤指标的应用。为分析振型归一化方法对梁结构柔度曲率类损伤指标的影响,根据梁结构的刚度、弯矩和位移曲率的关系,建立了均布荷载作用下结构损伤前后位移曲率与损伤程度的理论表达式,实现定量分析均匀荷载面曲率结构损伤程度。提出P-范数振型归一化方法,通过均匀荷载面曲率指标推导了振型质量矩阵归一化系数差x_α与损伤程度的关系。以三跨连续梁算例对理论进行了验证,结果表明,损伤程度定量指标效果良好,不同P-范数振型归一化方法下,损伤程度的偏差可由2x_α估算;2-范数振型归一化方法的损伤识别结果与质量矩阵振型归一化结果最接近,故当无法获得质量矩阵归一化振型时,可采用2-范数归一化振型代替。     

配位化学课程中研究型教学模式探讨

In this paper, the implementation of research-oriented teaching mode in coordination chemistry was introduced, including the strategies, main contents and evaluation.     

非化学专业无机及分析化学“讲练考”教学模式改革

This article discussed "teaching-practice-test" teaching mode with teaching practical experience and content matching.Results showed that this mode highlighted the proportion of practice and problem-solving in the process of learning; improved students' ability to solve problems using professional and disciplinary knowledge; changed learning styles from cramming way to autonomous learning step by step and trained students' creativity.     

Concise synthesis of dopexamine dihydrochloride via benzyl protecting protocol

Benzyl protecting protocol was first employed in two routes for the concise synthesis of dopexamine dihydrochloride.This protecting group could be cleanly removed under mild condition and no unacceptable ion was brought to the final product.The total yield of route I was 43.8% from phenylacetic acid,while it was 54.1% of route II from 2-(3,4-bis(benzyloxy)phenyl)acetic acid.The titration purity of the final product was more than 99.5%,while any single or total impurities met the known standard of the drug by HPLC analysis.The measured residual palladium met an acceptable limit(<1 ppm) as an API for injection.     

Disentangling stochastic signals superposed on short localized oscillations

We introduce a procedure for separating periodic oscillations superposed on a stochastic signal. The procedure combines empirical mode decomposition (EMD) of a signal with tools of data analysis based on stochastic differential equations, namely nonlinear Langevin equations. Taking the set of modes retrieved from the EMD of the signal, our procedure is able to separate them into two groups, one composing the periodic signal and another composing the stochastic signal. The framework is robust for a broad family of localized oscillations, in the range of large frequencies. In particular, we show that, in this context, the EMD method outperforms a low-pass filter and is robust for a wide interval of different frequency ranges and amplitudes of the periodic oscillation, as well as for a broad family of different non-linear Langevin processes.     

角锥棱镜谐振腔激光模式模拟研究

为了探究角锥棱镜谐振腔激光模式,以角锥-平面镜腔为例,将角锥棱镜等效为衍射光栅,考虑角锥镜棱宽在谐振腔中的衍射效应以及二面角误差引起的附加相位分布对谐振腔激光模式的影响,在光学谐振腔理论的基础上,建立了求解本征模式的理论分析模型.采用快速傅里叶法数值模拟不同腔长、角锥镜棱宽和二面角误差情况下该无源谐振腔激光输出模式分布情况.结果表明,在腔长30 cm、角锥镜棱宽小于75μm、二面角误差在-10′~5′之间时,可实现光斑完整的圆形分布输出模式,且有较好的光束质量;棱宽不小于0.4 mm,二面角误差在-40′~10′之间时,光斑为TEM 03阶横模,光场呈六瓣分布;当角锥镜棱宽为0.4 mm、二面角误差为3′,腔长从30~90 cm范围内增加时,该谐振腔输出的激光模式从TEM 03转换成TEM 10.     

Investigation of unstable motion characteristics of vacuum arc cathode spots between transverse magnetic field contacts

With the improvement of the current level of power grids, the requirements of the opening level of the vacuum switches are also increasing. Vacuum arc cathode spots provide steam and electrons and, to a certain extent, determine the opening capacity of the vacuum switch. In this paper, a vacuum arc cathode spot research platform based on the de-mountable vacuum chamber is constructed. The characteristics of the vacuum arc cathode spots under the transverse magnetic field (TMF) contacts are assessed by a high-speed charge coupled device. The experimental results show that the cathode spot diffusion process can be divided into three processes through cathode spot distribution, arc voltage and current: initial diffusion stage of cathode spots, unstable motion stage of cathode spots, and extinguishing stage. The motion mode of cathode spots during unstable motion stage can be divided into cathode spots group stagnation (CSGS) to multi-cathode jet (MCJ) switch mode, cathode spots group motion (CSGM) to MCJ switch mode, CSGM mode, and MCJ mode. The effects of peak current and contact diameter on unstable motion mode were analysed.